Snow Plowing Forum banner

snow sticking

1.9K views 5 replies 6 participants last post by  welded wrenches  
#1 ·
does any one know if their is any thing that I can put on my plow to keep snow from sticking to the boards.
 
#2 ·
#5 ·
Good ol' WD-40 works well, too. Nothin' fancy, and nothin' expensive. I would be HARD pressed to catch myself buying a $40 can of Pam cooking spray when Pam or WD-40 does the exact same thing and much cheaper.
 
#6 ·
Stainless steel moldboard

Hi all,i welded on a piece on on non-magnetic sheet on the entire moldboard.I used stainless weld wire.i welded some small tack welds at the top,and solid besd welds up the entire left and right side and no weldind at he bottom.The the cutting edge will hold that in place. This only added a few pounds of weight but atleast i have very little snow sticky to it.and it never needs to be painted.And the stainless steel was a freebie. NOW where is my stainless cutting edge? :)
:)