1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

Where to mount control box on 09 2500HD

Discussion in 'Blizzard Plows Discussion' started by turbo38sfi, Nov 28, 2009.

  1. turbo38sfi

    turbo38sfi Senior Member
    Messages: 289

    Just looking over my install of my 8100 I had done yesterday. They mounted the control box RIGHT where the dual battery would go on my 2500. I'm going to relocate it but not sure where yet. I haven't taken it off yet to know how much slack there is if any.

    Where is a good spot to mount that if you're running dual batteries?
  2. cet

    cet PlowSite Fanatic
    Messages: 7,257

    There is lots of wire that comes with the kit. If you are moving the iso box then you might have to rewire some of the things. I have my isolation module on top of my fuse box.
  3. beam

    beam Senior Member
    from pa
    Messages: 314

    put it on top the fuse box leave slack for removing the cover
  4. turbo38sfi

    turbo38sfi Senior Member
    Messages: 289

    I will check that out today. Need to do some rerouting too. The wire on the passenger side of the plow is VERY short, Not much slack there at all. Hoping there's another 4-5" in there I can play with.