Snow Plowing Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
163 Posts
Discussion Starter · #1 ·
Have the gray western 2" gray joystick electrical controller, and it must be sticking...

When going any direction it sometimes sticks, pull the wire back it works fine, does it sound like the joystick wire inside is bad? Pulled it apart and pulled wires back everything looked fine, must be just a fine little short inside controller, replace controller ?
 

· Registered
Joined
·
732 Posts
Take it apart again, and blow it all out with compressed air. I Had a controller that didnt angle to the left, I did the above and it worked ok for a while. I would get a new controlller just incase.
 

· Registered
Joined
·
2 Posts
Had a similar problem with my western mvp. MIne would not lift, every button in the controller would put plow into vee or scoop position. It wound up being a sticky valve in the pump. Go to western.com or your western dealer to find out which valve it could be. :cool:
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top