1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

used 810SS wing problem

Discussion in 'Blizzard Plows Discussion' started by KCAPXIS, Oct 3, 2006.


    KCAPXIS Senior Member
    from NE PA.
    Messages: 143

    the wing goes in and out just fine, but the right wing will not angle/ scoop. we took all apart, found out that the pin the wing pivots on is rusted,, we soaked area w/ WD40. several days, and was told by a local Blizzard guy to unhook the hydro lines to wing and then move wing with excavator, ect... to loosen rusted parts... the wing will move with lots of external force, ( excavator ) is there any tricks to get this pin out and or install ones that have grease fittings???
  2. Jerre Heyer

    Jerre Heyer Senior Member
    Messages: 948

    If it's the main pivot pin the trick to taking it out is pull the wing part way out and get a good drill bit. 1/4" then 3/8" then 1/2" then 3/4". Then pull it all the way out and flip it over and do the same thing. Drill two small ( 1/8) holes in the front of the bushing for grease and put a new pin in. Grease it. For the other side. Lube it up now. You can also pull it part way out and heat the top and bottom tabs and lube them with heavy grease to get them to move.

    Don't get them cherry red just hot enought to let grease go down them.