1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

TM 6.6 tractor mount question

Discussion in 'Meyer / Diamond Products Discussion' started by dgchaps, Mar 14, 2008.

  1. dgchaps

    dgchaps Junior Member
    from NY
    Messages: 2

    Hello -

    I just bought a used Meyer TM-6.5 and I plan to mount it on a Ford 601 tractor. It is in very good condition and I have the EZ-mount classic mount (came off a Chevy Blazer). At what height should the mount be ? I would like to know not only the optimal height, but for my case, what the minimum acceptable height can be. I suppose this would be measured from the ground to the "pin hole" where the plow itself connects to the mount. There is a choice of 3 holes there, and I presume I will be using the highest one as the mount will likely be lower than it would be on a truck.

    Any advice appreciated (other than "don't try it!")

  2. Milwaukee

    Milwaukee 2000 Club Member
    Messages: 2,180

    I have try but I can e-mail you pictures of snowplow mount to tractor so you can make copy mount then you could success do that.
  3. 84deisel

    84deisel Senior Member
    Messages: 697

    10 1\2 inches from ground to a-frame is what the meyer install guide says.Just make sure the a-frame is level then you will be fine.
  4. 04sd

    04sd Senior Member
    from pa
    Messages: 266

    You want the A frame to sit level. If the A frame is high in the back the leading edge will dig in with the plow angled. If the A frame is low in the back the leading edge will tend to lift with the plow angled.
  5. SnowLane

    SnowLane Senior Member
    Messages: 127

    Actually 10-1/2" is for the DT/C/HM series Meyer Plows. The TM Series should be 9-1/2".