1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

Speedcast electric pump conversion?

Discussion in 'Fisher Engineering Discussion' started by Phooey, Oct 30, 2011.

  1. Phooey

    Phooey Junior Member
    from NY
    Messages: 2

    Hi Folks.

    I need to replace my belt driven pump with an electric pump. What would be a reasonably priced correct pressure unit to replace it? I will be using the Fisher manual valve body.

  2. tractorbill

    tractorbill Member
    Messages: 65

    I have the old style Fisher electric setup you need.
  3. sweetk30

    sweetk30 PlowSite.com Addict
    Messages: 1,588

    basicly its 1800 psi for the operating specs. and also 2.0-2.5 gpm flow rate.
  4. Phooey

    Phooey Junior Member
    from NY
    Messages: 2

    Thanks Bill and Sweet.

    $$ Bill? I'm about 45 min away.

    The reason i need this is i'm putting the Speedcast from my '88 Chevy, onto a '98 F-150. Suprisingly the frame almost fell on, minus the push bars that the Chevy had. I need to make some brackets for the rear frame, but very simple. The engine in the Ford however, is not room friendly to a belt driven pump, although not impossible, a PITA. I have room for the valve body so i just need to pressure it.

    This is just for my own driveway.
  5. tractorbill

    tractorbill Member
    Messages: 65

    Sorry been busy. The old fisher pump that I have that uses the spool valve is very large and will not fit under the hood of your 150.You will have to go to out front electric.
  6. TJS

    TJS PlowSite.com Addict
    Messages: 1,440

    Look for a SEHP pump and you will be fine.