Snow Plowing Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
Hello. I have a sno way 24 series plow and I bought the buyers pro wings for it I already replaced the moldboard with a steel one and I plan on adding some supports where the wings will mount. Has anyone tried to do this before? I tried to follow the instructions with it but the curvature of the plow wont work with the pro wings. I could figure it out but I thought I'd see if anyone tried this before. I found this picture of a guy who did it but the poster hasn't been on this site since 2010

Camera accessory Automotive lighting Bumper Rectangle Gas
 

· Registered
Joined
·
531 Posts
I still have a couple of old Meyers with those wings. Total pain in the butt to mount, and welding the brackets on is the way to go, the bolts generally shake them selves apart. Use cclamps to mock the bracket location. But they are amazing additions for the money. Also make sure to overlap the cutting edge enough so the rubber doesn't go behind the plow.
 
  • Like
Reactions: Case Plow
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top