Snow Plowing Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
339 Posts
Discussion Starter · #1 ·
We have had Air Flo in our fleet for 25 years and they have a lifting bar towards the back that was perfectly center to lift the salter out of the truck. My question is what are you guys doing to get the Western V-beds in and out of the trucks.
Please if you can add a picture I would appreciate you help.
 

· Registered
Joined
·
246 Posts
Use the picture listed above.Run two chains, one from each corner of the hopper to the opposite corner, so they form a X in the Box. We use a skidloader with forks to lift on the chains and pick up the spreader about six inches. Then drive the truck out from under the raised spreader.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top