Question for boss rt2

deluxeco

Senior Member
Location
cleveland,ohio
Can anyone tell me if:
1.If I can interchange the 8.2 with the 9.2 steel rt2 v moldboards.
2.Interchange my steel 9.2 rt2 with the new 10' moldboards?
In addition I notice bending of the lower part of the moldboards that have resulted in a 1-1.5" gap between the top of the cutting edge & the moldboard near the pivot point,what is causing this?is this common?and any remedy for it?
Thankyou!:confused:
 
Top