Plow removal
1 - 7 of 7 Posts
Joined
·
17,725 Posts
1 Disconnect the two hydro hoses at the quick couplers,
2 pull the two pins on the bottom,
3 shift the controller into float and push down on the lift arm where the chain attaches,
4 unhook the chain.
2 pull the two pins on the bottom,
3 shift the controller into float and push down on the lift arm where the chain attaches,
4 unhook the chain.
Joined
·
10,617 Posts
That's an oldie!
See those two pins down there pull those and the hydro lines and unhook the chain.
![Tire Wheel Land vehicle Vehicle Vehicle registration plate]()
See those two pins down there pull those and the hydro lines and unhook the chain.
Joined
·
7,298 Posts
Western standard. Predecessor to the Unimount. Put rubber covers over the ends to prevent soot / moisture in the ends of the hoses.
Joined
·
7,298 Posts
Joined
·
14,949 Posts
ACTUALLY it's a Frankenstein setup.
It a unimount blade and a frame....with a conventional lift assm
Joined
·
7,298 Posts
Bird sell it to him?
1 - 7 of 7 Posts
