[purplehavoc]

Hey guys
New to the forums here and was looking for some help.
Picked up an old style western plow,the kind that the pump and motor stays mounted to the truck,and was wondering if anyone could help me with were the wires run,(been snipped).
Also do i wire the the plow lights into my factory light wires?
Thanks for any help.Great site.
John

 

[B&B]

I'm assuming this is a cable controlled pump since you said it an older style conventional mount. Here's a couple links to the Western manuals for the cable pumps..

http://www.westernplows.com/pdf/62880.pdf

http://www.westernplows.com/pdf/13280_080193.pdf

As far as wiring your plow lights, you will need to hard wire them into your factory truck wiring through a two position double pole toggle switch..

 

[purplehavoc]

Thanks for the info.
It is not a cable controlled pump.Has a solenoid with the power lead to the batt.
Has wires running from the pump that would go to the solenoid as well as the joystick in the cab.Has a smaller joystick similar to the uni mount control.

 

[B&B]

OK...then try these ones...

http://www.westernplows.com/pdf/13523_080092.pdf

http://www.westernplows.com/pdf/13520_091793.pdf

http://www.westernplows.com/pdf/3123-25_100180.pdf

 

[purplehavoc]

That hepled.
Thanks for the info.