1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

Meyers E47 wont raise or angle

Discussion in 'Truck & Equipment Repair' started by wmiller, Jan 3, 2014.

  1. wmiller

    wmiller Junior Member
    Messages: 1

    Friend of mines pump quite on him this morning. He cycled the plow a couple times and then would no longer lift or angle (pump runs but wont build pressure)

    Checked fluid level and was good. I checked all 3 solenoids and they are magnetizing. Pulled both screens and they look good. Pulled A B and C and o rings look good/ not contaminated.

    What else should I be looking at? Is there an internal seal on the pump that could have blown out or pump gone bad? Is there another place that could have a blockage?

    Messages: 62

    They make a Basic Seal Kit.Did you change the fluid?Ill see if i can find you the kit.

    Messages: 62

  4. leolkfrm

    leolkfrm PlowSite.com Addict
    Messages: 1,980

    ice add isopropyl dry gas to it and cycle