meyer plow problem

[laker]

I've got a problem with a 7 1/2 foot meyer.
with the plow angled to the right or strait every thing is fine
but when angled to the left the blade only touches the ground the first two feet on the right side
while the left side is 2 inches off the ground....
I assume some thing is bent
I did notice that the A fram on the plow had a slight
bend to one side.
Any thoughts would be greatly appriciated.

 

[SlimJim Z71]

I'm EXTREMELY tired... so if this sounds incredibly stupid, don't hold it against me.

Is your cutting edge worn a little crooked???

-Tim

 

[laker]

it is a little and wasn't sure if that was it

 

[SlimJim Z71]

Could be... there are a lot of factors involed with the angle your plow is on the ground at. The height of you plow mount, the angle of the A-frame, cutting edge wear... etc. That sounds like it could be your problem.

-Tim

 

[GeoffD]

If the A-frame is bent that sounds like it could be your problem.

Geoff

 

[KJ26]

Yes your A-frame is bent. I had the same problem wensday nite. What i did for a quik fix was put the right side pin in the upper hole and the left side in the bottom hole. good luck and happy plowing. If you guys get bored,make the trip to Buffalo,,we've had 65 inches already and it's still coming.