[rmorrison9773]

My Meyer 7.5 poly rides over the top of the stops. What should I check or how do I fix this?

 

[wild bill]

stops

i assume you are talking about the blade trip stop's ,if so find out where the wear is ,pin's,worn out stop's ,ect repair-rebuild the stop's.

 

[swa136]

My ST-90 was doing the same thing. I took the sector off, and found where it was worn. Two big fat beads of weld fixed it up nicely.:salute:

 

[B&B]

How about a pic? Might make it easier to see whats up.

 

[rmorrison9773]

Thanks all, I welded a small piece of angle-iron to increase the height of the stops. That should get me through until I can pull it apart and replace the worn parts.