Snow Plowing Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Currently working on a Meyer e58h. I install western and fisher plows regularly Do not have much experience with Meyer. Anyway the problem the customer is having is that is raises slowly. Side to side fine. i did the obvious. Fluid change and flush. Check power and grounds. Inspect b valve. Appears to be working out of valve body. The weird thing is that if I hit the up button briefly then hit it again it raises fine. But if I only hit it once it struggles to raise. Tried a different controller. No change. Any ideas? Not really sure why hitting button twice would make
A difference.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top