Md75 Plow movement

Discussion in 'SnowDogg Snow Plows' started by Icebox, Jan 19, 2020.

  1. Icebox

    Icebox Junior Member
    from NJ
    Messages: 22

    Hey guys, when my md75 is attached to my truck and lifted while driving, is the plow alone suppose to move side to side when you hit a bump on the road? I looked at my clevis pins where its loose from and they seem to be ok. Do they wear out that it causes the plow to move? Thanks in advance
     
  2. Avalanche 2500

    Avalanche 2500 Senior Member
    Messages: 818

    Ck. fluid level it should be just below the neck. Do u change it/ new strainer every other season? More than likely air in fluid > to fix loosen angle cylinders, place rags over start truck angle plow, tighten, top it off ?
     
  3. OP
    OP
    Icebox

    Icebox Junior Member
    from NJ
    Messages: 22

    Thanks for replying but it has nothing to do with the fluids or the angle cylinder. It's called a clevis pin (#8 on the diagram). When i drive with the plow lifted, it seems that its loose from the clevis pin area that makes the plow move side to side when i hit a bump on the road. Do these pins wear out where i have to replace them so the plow wont shake? Thanks for the help Screenshot_20200120-113159_Chrome.jpg Screenshot_20200120-113159_Chrome.jpg Screenshot_20200120-113159_Chrome.jpg Screenshot_20200120-113159_Chrome.jpg Screenshot_20200120-113159_Chrome.jpg Screenshot_20200120-113159_Chrome.jpg Screenshot_20200120-113159_Chrome.jpg Screenshot_20200120-113159_Chrome.jpg
     
  4. Avalanche 2500

    Avalanche 2500 Senior Member
    Messages: 818

    I have hd75 plow is off / went and ck. my c. pin it just about moves a 1/16" w/ fingers ? If yours moves a lot replace them? Just a thought ck. your welds?
     
    dieselss likes this.