1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

Iso Mod Waterproof?

Discussion in 'Fisher Engineering Discussion' started by Stik208, Mar 11, 2010.

  1. Stik208

    Stik208 PlowSite.com Addict
    Messages: 1,319

    I sprayed my engine with Simple Green last evening and rinsed it off, i didnt drown it my anymeans more or less a gentle mist to get the grime and grit off. In the course of this I sprayed the top of the Iso Mod with the Simple Green and rinsed it as well being it is in there. I see the plugs have a gasket around them and clip into it, question is basically do I have anything to worry about? I don't think I do/should but I figure I'd ask. Even though it is after the fact.
  2. RepoMan207

    RepoMan207 PlowSite Fanatic
    from Maine
    Messages: 5,039

    I wouldn't go dunking it in a bucket of water, but It should be fine. I would think the weakest link is the connector ports, however the weather pack connectors are pretty good in resisting water intrusion. I wouldn't make it a habit of blasting it with water in the future either.
  3. plowguy43

    plowguy43 PlowSite Fanatic
    Messages: 5,281

    I'd go ahead and uplug everything, toss in some electric grease, and plug them back in to make sure you don't get any water in there.
  4. Stik208

    Stik208 PlowSite.com Addict
    Messages: 1,319

    All works as usual.