1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

I NEED HELP changing 4x4 hubs

Discussion in 'Truck & Equipment Repair' started by Iceman551960, Feb 28, 2011.

  1. Iceman551960

    Iceman551960 Junior Member
    Messages: 9

    I purchased a 1973 International model #1110 4x4 pickup recently and discovered the hubs are bad. Everything I looked up said I need "Milemarker #302" replacement hubs. The instructions are very clear but generic. My problem is I can't seem to find anywhere instructions for International specific instructions. I removed the cover plate and slid out the "guts" which consisted of four springs attached to a thin metal plate on one side and a big gear on the other. The inside of the hub has a little gear with a retaining clip. Since the "new" set had the little gear inside the big gear, I assumed that I needed to remove the retaining clip and the little gear inside the hub. The little gear is attached to the spline. It doesn't come out. I don't know what I'm doing in the first place, but I did watch a video online and it didn't look too difficult. Also the housing that the cover plate (dust cap) attaches to is too small in diameter for the new set to slide into . Do I have the wrong replacement hubs? I need some major help and dumb it down please. It's my first time.

    NICHOLS LANDSCA PlowSite Veteran
    Messages: 4,362

    Should be a Dana 44 axle same one used in GM, Dodge, Jeep. Maybe you will have more luck finding a picture if you look it up that way.
  3. justme-

    justme- 2000 Club Member
    Messages: 2,138