1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

How to wire strobe beacons

Discussion in 'Strobe Lighting' started by CashinH&P, Nov 27, 2013.

  1. CashinH&P

    CashinH&P Senior Member
    Messages: 448

  2. JB1

    JB1 Senior Member
    Messages: 182

    Have you looked at YouTube?
  3. fordtruck661

    fordtruck661 Senior Member
    from CT
    Messages: 404

    Ok LED is simple. If you are buying the permanent mount it will have 3 wires (red, black, white) First you need to set the light ID#. If you want them Alternating set one light to #1 and the other to #3. After that you have to select the flash pattern. Once all of that is done its as simple as hooking up red to a switch and black to a ground.

    To do it the right way run 18 gauge wire to the + side of the battery and add a 5 AMP inline fuse at the battery. connect that wire to the switch and then run wire from the switch to your lights. For the ground for your lights just run it to the closest meal surface.

    Here is the install sheet. Refer to page #2
    http://www.soundoffsignal.com/sites...ies LED Beacon Class 1 Installation Sheet.pdf
  4. CashinH&P

    CashinH&P Senior Member
    Messages: 448

    Thanks, that is exactly what I was looking for. I had gotten 3 answers from 3 diferent people.