Snow Plowing Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
723 Posts
Discussion Starter · #1 ·
my salter auger motor might be on the way out, was working good full and empty for a few weeks. then loaded it up it work a few times but then the control flashed 10 and said OL. I jumped to auger motor and ran 12V direct the motor kick on. then I hooked the controller back up and it worked.

my question is how do I test the amp draw on the motor, snowex said it should be 14-17amps when empty
 

· Premium Member
Joined
·
17,038 Posts
my salter auger motor might be on the way out, was working good full and empty for a few weeks. then loaded it up it work a few times but then the control flashed 10 and said OL. I jumped to auger motor and ran 12V direct the motor kick on. then I hooked the controller back up and it worked.

my question is how do I test the amp draw on the motor, snowex said it should be 14-17amps when empty
With one of these

Rectangle Yellow Measuring instrument Material property Temperature
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top