Ground post broken

Discussion in 'Fisher Engineering Discussion' started by Joe Lombardo, Feb 25, 2008.

  1. Joe Lombardo

    Joe Lombardo Member
    Messages: 62

    I was attempting to remove the ground cable which attaches to the side of the plow motor and broke the grounding stud off. Do I have to replace the motor or does anyone know of a way to remove the stud. I have attempted to back it out but it just turns.the plow is a MMII Any suggestions???
     
  2. zeebea

    zeebea Junior Member
    Messages: 8

    motor

    I think (not 100% sure as I sit inside) you can take the cover or shroud off the motor. There are I think 2 long screws in it. the brushes are going to pop out but with a couple of long skinny screwdrivers are easy enough to put back in. Like I said not 100% sure but you should definately be able to get it apart.
     
  3. wirenut

    wirenut Senior Member
    from nh
    Messages: 542

    new motor is 138$$ but you should be able to replace
    the stud once you get it apart pretty easy
     
  4. OP
    OP
    Joe Lombardo

    Joe Lombardo Member
    Messages: 62

    Had the motor replaced today $149.00 installed. Thanks for your suggestions