Snow Plowing Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Felt I should post this in hopes it will save someone and bunch of time and frustration
MM2 was slow all directions and noises, checked all post and web...changed fluid, filter, pick up tube, motor. Cleaned all connections ( those were the posted fixes) Non worked!!! Ugh
Here was the fix...... when you change motor there is a small (1/2” in diameter) brass sleeve that acts as a bushing between the motor shaft and pump bulk head wall that was worn to the point of paper thin...
removed that and replaced (comes with fisher tank seal kit) PROBLEM SOLVED!!!!
Works like new ... Hope this helps
JB 3939
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top