E60 trouble shooting

Discussion in 'Meyer / Diamond Products Discussion' started by Cowboycurb, Oct 28, 2019.

  1. Cowboycurb

    Cowboycurb Junior Member
    from Wyoming
    Messages: 1

    I just bought a used plow truck that has a meter E60 plow on it. It will not raise or lower. I was going to replace the B valve but what socket size is needed to do this? Also is it normal to be able to move the blade from side to side or should the rams hold it to one angle or the other until you tell it to move?
     
  2. Randall Ave

    Randall Ave PlowSite Fanatic
    Messages: 10,024

    7/16 on the top to remove the magnet, then should be 1 1/4 deep socket to remove the valve. No the blade should not be moving far back and forth.
    Have you checked the fluid level? Does it try to angle?