E60 Angle Issue Again, No Doubt

Discussion in 'Meyer / Diamond Products Discussion' started by djkrash, Oct 7, 2019.

  1. djkrash

    djkrash Junior Member
    from 16701
    Messages: 2

    Here's the tale of woe so far. Truck comes to me with left angle only no matter what. Check power all the way to C coil. Replaced both sets of couplers, male and female. Replaced C coil and valve w/ new. Still no right angle. Took all hoses apart to make sure that was not and issue. Checking the go/no go chart in the Meyers shop manual, we are now at cleaning the x-over valve. Undid that and received a face full of oil under pressure. Checked and put it all back together. Same issue. The coupler for the right ram issue under enough pressure that I cannot uncouple it w/o bleeding it off. My next step would be to replace the x-over relief? Any other ideas? By the bye, how strong should the magnetic field be on the outside of the C coil?
     
  2. Randall Ave

    Randall Ave PlowSite Fanatic
    Messages: 10,005

    If you have the coil and valve on the bench, put 12 volts to it, you should hear it click. I would say replace the crossover relief valve.
     
    Hydromaster likes this.
  3. OP
    OP
    djkrash

    djkrash Junior Member
    from 16701
    Messages: 2

    Thank you.
     
  4. Randall Ave

    Randall Ave PlowSite Fanatic
    Messages: 10,005

    That's my best guess, the Meyer expert has not been on in a while.
     
  5. leolkfrm

    leolkfrm PlowSite Veteran
    Messages: 3,054

    bump it against something solid and see if it goes right
     
    Randall Ave and Hydromaster like this.