[E47 meyer]

I'm comfuse silenoid wont click left and right but clicks up and down when I move the controler left or right I have no clicks on silenoid. Any help please

 

[E47 meyer]

I need help please it's a new silenoid and everything look connected correct but when I press left or right on controler silenoid dont click or move the plow any idea why only move up and down and silenoid clicks.

 

[samcarpen]

Under hood solenoid should not click when plow is going down. Sounds like you have crossed up control wires at the pump.

 

[E47 meyer]

Ima make sure now. Thanks.

 

[E47 meyer]

Yeah going down solenoid does not click

 

[Randall Ave]

Need better clarification. The plow goes up and down, but will not angle?

 

[samcarpen]

Sounds like a controller issue.

 

[E47 meyer]

Yes it wont angle and solenoid wont click either but I connected my prob test light and hit positive on the pump wires and all 3 cables make pump click.

 

[E47 meyer]

Sounds like a controller issue.

I have the old controler with the 2 joysticks ?

 

[E47 meyer]

When I move the joystick left or right I get no click on solenoid

 

[Randall Ave]

Lets try this again, will the plow raise and lower? If yes, try a different controller, and your joystick has two levers, put up a picture of that.

 

[samcarpen]

Try cleaning/reseating connections at the controller.

 

[E47 meyer]

Need better clarification. The plow goes up and down, but will not angle?

Yes up the solenoid clicks down it dont click and left or right I dont get no click from solenoid

 

[Randall Ave]

First off, the solenoid is under the hood of your truck. Now there are three valves with magnetic coils on them at the pump. So, does the plow raise and lower, this is a yes, or no question.

 

[samcarpen]

Internal contacts in the angle joy stick could be corroded. Try spraying lubricant and electrical contact cleaner where the stick pivots.

 

[E47 meyer]

First off, the solenoid is under the hood of your truck. Now there are three valves with magnetic coils on them at the pump. So, does the plow raise and lower, this is a yes, or no question.

Yes

 

[E47 meyer]

Internal contacts in the angle joy stick could be corroded. Try spraying lubricant and electrical contact cleaner where the stick pivots.

You thinks this will work ?

 

[samcarpen]

Can't hurt to try. Other option is replacement which was suggested earlier.

 

[kimber750]

Angle switch is bad if coil gets power and solenoid doesn't. The switches are cheap. Test to make sure you have power at both center terminals on switch.

 

[E47 meyer]

Can't hurt to try. Other option is replacement which was suggested earlier.

Thank you so much now I know it was corroded I apply the contact cleaner now solenoid switch left and right you are good.