1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

Drop speed xls

Discussion in 'Fisher Engineering Discussion' started by leigh, Nov 28, 2015.

  1. leigh

    leigh 2000 Club Member
    from CT
    Messages: 2,342

    Got plow set up and ran plow through bleeding process.The plow drops like a rock! Adjusted Quill on the rear of valve body on the drivers side.Kept adjusting till it was all the way in! Still drops like it will break through the concrete floor! How sensitive is this adj.? My mm2 drops much slower and I can drop it on dollys without breaking them(1450 lb mc) Is there any possibility that it is defective ? The 2nd plow is almost setup so I'll compare with that one to see if this is just the way they are. Thanks
  2. Arc Burn

    Arc Burn PlowSite.com Addict
    Messages: 1,141

    Sounds crazy but "get on" that screw a little more,i see a lot of them that seem to bottom out but they just hit a spot and feel tight,odds are it will go more.
  3. kimber750

    kimber750 PlowSite Veteran
    Messages: 4,681

    Last XLS I installed had a piece of debris in the quill. This was a new install but like Arc said this have to be pretty tight before they make any noticeable difference.
  4. leigh

    leigh 2000 Club Member
    from CT
    Messages: 2,342

    Heading to shop. I'll check it out again now that I have more time. Thanks