double tap up fail (no movement) question

Discussion in 'Boss Plows Discussion' started by dmacleo, Nov 10, 2019.

  1. dmacleo

    dmacleo Member
    Messages: 68

    is double tap up driven off controller or relay pack?

    got one truck (have not had access to test different controller) where all functions work except double tap up. same blade on different truck days before worked fine. so know its not blade issue.

    press to raise works normal, left/right/down/float all fine. just that one single function fails. zero pump activation when up is double tapped.

    iirc this is controller driven alone but truck has known wear in 13 pin harness and relay pack, just want to solidify mindset before I look at truck.

    thanks
     
  2. cwren2472

    cwren2472 PlowSite Fanatic
    Messages: 6,910

    Its driven by the controller. Do you know if it ever worked on that controller? Because not all controllers supported it
     
  3. dieselss

    dieselss PlowSite Fanatic
    Messages: 13,341

    Amy tell you that?
     
    Mark Oomkes and Randall Ave like this.
  4. cwren2472

    cwren2472 PlowSite Fanatic
    Messages: 6,910

    Not uh. I just know stuff.
     
    dieselss likes this.
  5. OP
    OP
    dmacleo

    dmacleo Member
    Messages: 68

    yeah it worked last year on multiple blades, figured was controller pretty sure we have spare I will get tossed into truck.
    if one function failed prob not long before other function on that same button press fails.
    thanks all.
     
  6. Jakedaawg

    Jakedaawg Senior Member
    from N. Mi
    Messages: 156

    If you want to sell one that doesnt have that stupid auto-up I'd be a buyer.
     
  7. cwren2472

    cwren2472 PlowSite Fanatic
    Messages: 6,910

    Brand new controllers are programmable to disable it