Snow Plowing Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
6 Posts
Discussion Starter · #1 · (Edited)
We have a 2006ish 8.5MVP, it is a early ultra mount. The cutting edges use the center flap piece, that has been busted out a time or two, which leaves a very annoying trail down the center. The newer style cutting edges either have an angle built into the end or they have an add on piece that bolts into the section. Does anyone make anything that would work for the older style V plow?
 

· Premium Member
Joined
·
17,303 Posts
We have a 2006ish 8.5MVP, it is a early ultra mount. The cutting edges use the center flap piece, that has been busted out a time or two, which leaves a very annoying trail down the center. The newer style cutting edges either have an angle built into the end or they have an add on piece that bolts into the section. Does anyone make anything that would work for the older style V plow?
No.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top