Snow Plowing Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
3,952 Posts
1- Meyer never released much info about these units, and some of the info was also wrong
2- Not enough home plow owners come here, to share information, so there is little people here can help you with
3- Your best bet is to find someone and take a picture of the extension harness plugged into the controller, so you have a record of how the wires connect. Otherwise, buy the short harness and a new controller, or guess and chance burning up the controller you have. The harness is $50, a controller is less than $300
Why are you buying "solenoids"? Anyway, the coil comes off the valve by removing the nut. Then the valve unscrews from the power pak.
4- Look for a aftermarket cylinder on the net
5- If it helps, the default action for your plow is "raise". This means if you run the pump with no power to any of the 2 valves, plow will raise. Apply power to the s1 valve to lower. The controller uses electronics to control "lower" and "float"
 

· Registered
Joined
·
3,952 Posts
Oh, "possibly" these people may help you with wiring, as the make Meyer harnesses and such-
 
1 - 2 of 2 Posts
Top