1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

Converting from PTO to engine driven pump

Discussion in 'Truck & Equipment Repair' started by 69800, May 13, 2009.

  1. 69800

    69800 Junior Member
    Messages: 2

    I am changing my truck over to engine driven hydraulics using the power steering bracket. It is a two hole mount 4 inch center. It lines up with the extra pulley on my crank shaft. My local hydraulic shop has a pump that fits with 4 gpm flow and 2000 psi. It also has a reservoir on top which look like it holds about a quart and a half of fluid. my blade is currently powered up and down also left and right. Can any one think of a reason this will not work?

    is this enough gpm and psi? I will be running it on a single v belt.

  2. got-h2o

    got-h2o 2000 Club Member
    Messages: 2,440

    Is something wrong with the PTO?
  3. 69800

    69800 Junior Member
    Messages: 2

    I do not like the pto because every time I stop to back up I have to put it in neutral and let the clutch out in order to raise the blade. Live hydraulics are much better.