buyers controller with lesco spreader?

Discussion in 'Ice Management' started by firebug130, Feb 22, 2008.

  1. firebug130

    firebug130 Member
    Messages: 37

    I have a lesco easy load spreader. It has the connection that is the same as my buyers tailgate spreader. I have the Buyers controller that works fine. my question is will my buyers controller work with my lesco spreader? I didn't know if these two were compatible.

    Thanks
     
  2. basher

    basher PlowSite Fanatic
    from 19707
    Messages: 8,985

    Should work.
     
  3. OP
    OP
    firebug130

    firebug130 Member
    Messages: 37

    I thought since the connections were the same that it would work. I mean a controller is a controller correct? I was not sure if the new bigger spreader motor pulled more amps than the small one that was on the buyers tailgate spreader. I don't even know if that matters. I had it on a 15 amp fuse, should i increase fuse size?
     
  4. Clapper&Company

    Clapper&Company PlowSite Veteran
    from NE OHIO
    Messages: 4,399

    Been there done it even have the shirt :D :salute:


    Yes it will work 100% fine :waving:
     
  5. OP
    OP
    firebug130

    firebug130 Member
    Messages: 37

    Thanks for the help. I thought it would work but just wanted to check.
     
  6. Clapper&Company

    Clapper&Company PlowSite Veteran
    from NE OHIO
    Messages: 4,399

    Any time...


    PM me you adress, so I can send you.. your bill :D