Boss Terminal cleaning?

Discussion in 'Boss Plows Discussion' started by sixty4, Jan 19, 2020.

  1. sixty4

    sixty4 Senior Member
    from CT
    Messages: 132

    Noticed Boss make a cleaning tool for this. Could I dip the connectors in white vinager and use dialectric grease, instead of buying the tool?
     
  2. OP
    OP
    sixty4

    sixty4 Senior Member
    from CT
    Messages: 132

    Worked well with, just soaking them.
     
  3. Kingsmen20015

    Kingsmen20015 Member
    Messages: 91

    Electrical spray cleaner, q tip , fluid flim worked for me. Hope that helps.
     
  4. BossEric

    BossEric Senior Member
    Messages: 275

    I've used brass wire pipe cleaners and CRC electrical cleaner for years . Even WD-40 with good results. But I did purchase the BOSS tools this season , and they do a good job. You can buy a similar set on Amazon for a little cheaper than BOSS sells theirs for , but not much cheaper.
     
  5. dmacleo

    dmacleo Member
    Messages: 86

    I also use the CRC to clean and a small brush or q-tip.
    do NOT over do the dielectric grease as so many do.
    too much kills contact, I only use it on the sleeves themselves.
     
    Hydromaster and Kingsmen20015 like this.