I've got a Boss RT3 that I used last year on my F250 with no issues. I'm hooking everything up for this winter and I've got no power to the plow or the control. Where do I start to find the culprit? I I'm hoping it's a simple ground wire that's come loose or corroded, but wanted to see what the best procedure was to troubleshooting no power issues.
FYI, this was a used plow and truck so I'm not sure who did the install or if all the wiring schematics were followed exactly as specified. I did check the relays and one of the spades on each relay were super corroded and gross, but I cleaned them and put them back in with no luck. Again, I assume it's a ground issue because plow, headlights, solenoid, and controller have no power.
Thanks
FYI, this was a used plow and truck so I'm not sure who did the install or if all the wiring schematics were followed exactly as specified. I did check the relays and one of the spades on each relay were super corroded and gross, but I cleaned them and put them back in with no luck. Again, I assume it's a ground issue because plow, headlights, solenoid, and controller have no power.
Thanks
