Snow Plowing Forum banner
1 - 17 of 17 Posts

· Registered
Joined
·
17 Posts
Discussion Starter · #1 ·
Ok, bought a unimount for an ‘04 Silverado 2500hd, upgraded from the relay harness to the 3 pin harness and isolation module. Upgraded the plow side also. Now I’m looking for the cheapest route to new lights that will plug in to the western harness. Is there a set out there that will do that or is that only if I buy factory lights. Thanks for the insight in advance.
 

· Registered
Joined
·
7,298 Posts
The OEM dual halogens will do so, though you'll need extension brackets for them to fit or you'll need to modify the light bar
Do those lights plug into the odd 3 plug end inside the old unimount housing ? It's not a standard 3 prong end in there, but that offset single blade odd setup that I've had to make adapters for. Works fine, but a pain to have to adapt stuff.

I assume you're gonna have to cut, splice, and heat shrink, no ?

Blue Finger Plastic bottle Thumb Gas


Finger Gas Electrical wiring Thumb Electronic engineering
 

· Registered
Joined
·
58,836 Posts
Plug and play will be OEM only. I'm not aware of any aftermarket option that is plug in compatible
Someone should modify some Trucklite LEDs with DD plugs and sell them...
 
1 - 17 of 17 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top