Any one use back drag edges w/ Etreme V yet?

Discussion in 'Commercial Snow Removal' started by Brian Young, Feb 14, 2008.

  1. Brian Young

    Brian Young PlowSite Veteran
    Messages: 3,487

    I am fed up with having to back drag then push then back drag again, each driveway. I had Fisher back drag edges on before but they were a little taller then the cutting edge by almost an inch but that was after I found out my brand new plow wore down the edge almost an inch in 6 hrs or so. I havent tried them with a brand new edge yet. Do they line up the same? or is there still a difference between the two edges and how well do they work?
  2. trmotorsports

    trmotorsports Junior Member
    Messages: 10

    I tried the back drag edge with brand new cutting edges and they were still taller than the cutting edges.
    I went back to the shop and took them off and wont put them back on.......
    What a waste of money that was...
  3. OP
    Brian Young

    Brian Young PlowSite Veteran
    Messages: 3,487

    Tyler, thanks for saving me 200 bucks! lol. You would think making them the same height would be a simple process.