Snow Plowing Forum banner
1 - 3 of 3 Posts

·
Premium Member
Joined
·
16,227 Posts
The short answer is no

The long answer is I don't know what I'm looking at in those photos. The upper left is a 3 plug setup, plow side. The middle right photo is 2 plugs of the same 3 plug plowside setup, but it looks like be from a dirtier and crappier setup. The lower left appears to be the exact same thing also but too blurry to really make out. I can't count the male pins but I can see the plow frame below it, it has the same male 2 pin plug, and the same 11 socket plug. So the only possible remaining one is another 11 male pin connector. So none of those show a 2 plug setup or a truck side setup.

In any case, the truck side would either have:

3 plug: A power plug with 2 female sockets, a 3 pin (or 7 pin) connector with male pins, and an 11 pin connector with female sockets
2 plug fleet flex: A power plug with 4 female sockets (2 large and 2 tiny in the middle) and an 11 pin connector with female sockets
2 plug relay: a power plug with 2 female sockets and a 12 pin connector with female sockets.

There are 2 different 2 plug setups -

the old relay style will have 12 holes on the main plug on the truck side, 2 of which are bigger than the rest. The connectors are different and won't plug into the 3 plug plow

The newer style fleet flex 2 plug will have an 11 pin and a 4 pin - the 11 pin is the same and would let your controller light up but if you tried to connect the other one for the power the motor will start running immediately until you unplug it and you won't be able to operate the plow anyway because you will be missing the 3rd control plug entirely

Even though the fleet flex power plug has 4 pins, it'll connect to most of the 2 pin power plugs (incorrectly) because they reuse the same molded ends. The other two tiny sockets simply have nothing inside them.
 

·
Premium Member
Joined
·
16,227 Posts
So based on your other thread, you have a 2 plug relay style


So that plow will not plug in at all as is - the pins are a different number, different size, and aren't even laid out in the same pattern
 

·
Premium Member
Joined
·
16,227 Posts
If I am reading this correct?

IF you have 2 plug relay, NOT fleet flex

You will not be able to use headlights on plow.

You can however make an adapter that will allow you to use the lift, left, right, and drop functions on a 3 plug plow using a two plug relay style truck to operate it.
He made another thread where he stated he intends to rewire either the truck or plow so they match - his post here was asking if he'd be able to run it temporarily in the meantime just to transport it home.
 
1 - 3 of 3 Posts
Top