Snow Plowing Forum banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
Have a Suburbanite plow on the front of a 2003 Sonoma (S-10) that we use for really tight drives on lake properties. A short melted a hole halfway down the the plow-side connector and then spread to melt the truck-side connector as well. Searching for replacement, I was told by a large Madison WI distributor that all he could get was the 12-pin set (P#s 49310 and 49319), yet the set on the plow has 11 pins. I don't need the whole harness, just the 11 (or 12?) pin wire/connector set.

So, anyone know the 11-pin P#? Or can I use the 12 pin instead? Need to know A.S.A.P as 7+ inches are inbound for Dec 28!

Thanks in advance.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.