Snow Plowing Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-18 of 21 Results
  1. Used Plowing and Truck Equipment Forum
    2015 F550 stainless dump truck with 2019 Western wideout XL and Henderson SS tailgate salter. Central hydraulics power dump bed and salter. 54,000 miles fleet maintained. New long block engine from Ford installed at 48,000 miles under warranty preformed at local dealer. New tires all around...
  2. Western Plows Discussion
    Hi Guys, we have a 2000 western unimount pro plow that came with a new truck we bought. Plow hooks up to truck no problem, connect fine. Transitions headlights to the plow frame headlights, and powers the plow controller inside the truck. But I have no movement of the plow. Cylinders are free...
  3. Heavy Equipment
    Does anybody out there have one on their tractor? If so where did you get it? When the hitch bounces does the tractor try to correct this? Would really like to get something like this setup for comfort and wear and tear. Thanks for any info.
  4. Truck & Equipment Repair
    I’m currently troubleshooting a wing extend problem i’v been having since the last snow fall. When I try and extend the wings simultaneously, the left wing extends normal and the right wings starts about half way and than stops until the left extends all the way. This was not the case until the...
  5. Truck & Equipment Repair
    Ive got a blizzard power hitch 760 which i have racked my brain over for the past week. All functions work great except right angle. Checked lines. Solenoids. Valves. Valve body. Im stumped. It acts as though it hits its max right angle just past straight. Any ideas would help. Thank you.
  6. Fisher Engineering Discussion
    I recently hooked up a older fisher plow to my truck. It's a 9ft plow with cables that operate the hydraulic motor. The motor is on the plow frame not under the hood. The issue I have is the plow goes up, down, and right but does not go left. It's not pumping fluid into the right ram I believe...
  7. Fisher Engineering Discussion
    Hi Everyone, I'm new to the site and I have searched for a while looking to see if I could find a post that already asked my question but I have been unsuccessful. I got a great deal on a old hydraulic only fisher plow setup and I decided to pick it up and install it on my 2000 F-150. As...
  8. Truck & Equipment Repair
    Have a quick question about the hydraulic jack piston assembly in the plowframe. How the f$*k do you remove it I ordered to replace the hose? Ive had this plow since brand new in 2005 and have had almost zero problems with it. I just blew a lift hose the other day so i had the pump out to...
  9. Introduce Yourself to the Community
    Hello all! I'm trying to decide whether to buy this truck and plow or not. It seems like a great deal, but i have one question. The plows electrical is not set up so I can't see the plow work quite yet ( I generally trust the guy so I'm not too worried). The hydraulic arms move in and out...
  10. Introduce Yourself to the Community
    Hi, I bought a used 2004 Chevy 3500 Silverado dump body and put a under tailgate spreader on it. The dump bed worked fine the last 2 months and even the first 2 days of spreading. At the end of the 2nd day we stopped for 3 hrs to shovel driveways. When we were leaving and tried to put the bed up...
  11. Truck & Equipment Repair
    I am having an issue with a slow right angle along with not holding pressure, Left and up work perfect. Its an older Minute mount electric. I have swapped left and right hoses on the pump and the problem follows, it goes slow on left and no pressure. So I do not suspect cylinders. Is it possible...
  12. SNO-PRO PLOW AND ACCESSORIES by Curtis
    i recently did a fluid change on my sno pro 3000 and i replaced the angle lines and the lift for this year, but after i put everything back together, my hydraulic jack doesnt work because i believe it needs to be bled. the fluid in the line drained out as i did not replace this one cause i knew...
  13. SNO-PRO PLOW AND ACCESSORIES by Curtis
    I bought a Curtis Sno-Pro 3000 last winter used. I flushed the hydraulic lines and refilled it with Curtis plow hydraulic oil last winter as well. When I took the plow out of the garage on friday for our little snowstorm, everything worked fine. As soon as the snow and temps fell in the 20's...
  14. Western Plows Discussion
    Replaced angling hose approximately 2 weeks ago. Added hydrolic fluid, everything worked fine and wonderful. Approximately 1 week later, the plow would not go up, and I had to add fluid. Today, the plow worked for Approximately 5 minutes, and now will not go up or angle. The resovouir is...
  15. Meyer / Diamond Products Discussion
    I've been browsing the forums here for some time, and this site is awesome. I couldn't help but join up. This rocks. Let me start by saying: I'm very new to this. This will be my second year of plowing (and by plowing, I mean my driveway and a few other friends' driveways and generally receive...
  16. Truck & Equipment Repair
    I bought a truck that had an E-60 Meyer Plow on it I am not familiar with the Meyer series plows, and there is no close dealer or service up here in northern Michigan. I can do repairs but i am not a hydralic wizard, and I know there are some easy tricks to diagnose problems. My pump motor was...
  17. Truck & Equipment Repair
    Well, I have a problem and hope someone might be able to help. I actually used the search function, to no avail. I need to fix one of the seals on my skid steer. It's leaking around the chrome rod. My question is this- When I disassemble the cylinder, does the piston bolt to the rod end...
  18. Used Plowing and Truck Equipment Forum
    Bonnell stainless steel replacement tailgate spreader all hydraulic dual auger with hydraulic spinner 2800.00 great shape
1-18 of 21 Results
Top