Search Results for ‘buyers’

My spreaders motor quit on me. Turns out, if you smack it with a hammer hard enough it will break the magnets inside. Buyers motor is 215ish Gladiator on ebay motor is 120ish. Has anybody had experience with the gladiator motor? Does it attach to the augor with no issues, and is the wiring...

Hello. I have a sno way 24 series plow and I bought the buyers pro wings for it I already replaced the moldboard with a steel one and I plan on adding some supports where the wings will mount. Has anyone tried to do this before? I tried to follow the instructions with it but the curvature of...

So I just bought a used truck which came with a MD75 on it and the problem I'm having is it won't go into float mode. I've checked all the wiring at the front two plugs and they're both plugged together tightly and ziptied together, I checked the wiring in the SA solenoid and it's all connected...

Salt/Sand Spreader Buyers SHPE2000 Salt Dogg Electric Drive 3/4 or 1-Ton Trucks Poly Box Spreader Used one season. (Purchased 2012?) Includes control box, grate, and cover. Wiring from box to cab not included May need vibrator replaced (available for $99) Capacity - 2 cu. yds. Hopper...

$50. Located between Boston and Providence. Buyers SnowDogg Plow Truck Mount for Nissan Frontier - believe it fits 2005 & Up. Mine was a 2006 Installed new in Nov 2014 on 06 Frontier. (MD75) Great shape. Always garaged. Moving to Southern California, sold the plow. Russell 401-824-4853

I have a serial number 3340 saltdogg shpe2000.. so first gen elec (apparently).. My controller fried 1 (one) transistor.. so I bought another controller (before learning about Karrier, of course) * I like this site: (http://garyae.com/page2.htm) free shipping too The new controller is a...

92 ford f250 4x4. 80,000 miles. 7.3 non turbo with auto trans. I bought the truck 2 years ago, since then it's only been a back up plow truck for me. I have replaced the following :brake lines, fuel lines, starter, alternator, power steering pump, wiper motor, batteries, misc. front end parts...

I built 6 inch wings for my western pro plow last winter and they work great. I was thinking about making up a few more sets and selling them, but i thought id check with the forum here and see if you all thought there is enough interest in them. I modeled them off of the wings for the pro...

During the summer I bought a brand new TGSUVPROA spreader. A hitch mount with in cab variable control. I hooked it up, tested it and everything was fine. The first time I actually used it to salt I ran into a problem. After a few runs, I would turn it on and no matter where the speed dial was...

Hello, Sorry to bring up a topic that has probably been discussed more often than not. I have a TGS05 spreader and ran some bulk last year and didnt have a whole lot of issues, but i was wondering everyone elses opinon on the situation. I bought a vibrator kit for it this year in hopes that...

I found this on another site, thanks to basher... DOUGLAS DYNAMICS, L.L.C. FOR IMMEDIATE RELEASE October 19, 2010 Douglas Dynamics, LLC v Buyers Products Company Western District of Wisconsin Jury Trial Verdict Milwaukee, WI – On October 14 and 15, 2010 a jury in the Western District of...

Anyone have any info on the Buyers TGS06 Tailgate Spreader. It's got a vibrator not the Auger (TGS07). Same size and a few hundred less.

Two years ago I purchased a SnowEx 8000 Vee Box spreader for my 2500HD. I went through three control boxes as they continually threw error codes or just plain fried. A rep from SnowEx even came to the dealer to try to troubleshoot the problem. His solution, give me a whole new spreader...

I had to take carb off Briggs 10.5 hp in order to clean it out due to improper storage and did not pay enough attention to the carb linkage which goes somewhere allowing the "in cab" controller to choke the motor when starting. I have looked on the Briggs and Stratton website but the parts...

Crysteel Truck Equipment in Minneapolis, MN Right now we are offering 6% off on all Buyers Snow Dogg Plows and shipping is less than $300 no matter where you want it shipped to. Check out our prices by clicking here or email us at: [email protected]

And No this is not my first time! Heres a dumb question I can't get my plow off my truck. Well first of all I couldn't get it on the whole minute mount theory took 90 minutes instead just to get it on. Before that I went and got a yard of sand/salt mix. Today I tried to take it off still with...

7.5' Meyer Plow for sale. MDII Mount with Night Sabre Lights. This plow was in use until 2007. It came off of a 2003 GMC Sierra 2500 HD. I have all the wiring and mount for the truck side ('03 GMC) for the plow. Package includes the Meyer touch pad. Extras include plow jack, spare touch...

I just picked up a 2 yd SaltDogg poly spreader I cant wait to use it. I was on here last season and was convinced so I purchased one. I just hooked it up this past weekend and was wondering what would be the best position for the two opening adjusters at the bottom of the spreader for either a...