Search Results for ‘boss’

Original owner and I'm the only operator. I just purchased a new BOSS TGS 600 as I do every few years and have my complete salter with wiring and controls now available for sale. This spreader has the upgraded RT3 mount instead of the regular 2" hitch which makes installation prior to a...

I recently bought a used BOSS plow and harness kit for a 2001 Jeep Wrangler. I have managed to connect everything but the plow has two issues. 1. When I turn on the switch for the plow lights, the plows' lights turn on, but the jeep's lights will remain on. When I switch it to just the jeep the...

I have a 2006 Chevrolet Silverado 2500HD and a Boss 8.5' Straight blade plow. I bought a retired landscaping truck this summer to pull a new camper I bought. It had the hookup for a plow which I purchased a few days ago. So here is the problem. The right turn signal doesn't work. I tested...

I've had a problem with the unmounted plow seeming to sink into the driveway over a little bit of time. This means it becomes too low to mount it again without jacking it up. I finally tried just sticking a 2x4 under it (see picture) when I took it off the truck. This keeps the plow from...

Older Boss B-8 skidsteer 8’ box snow pusher. Has a lot of life left in cutting edge and side skids. Sold AS IS asking $2,250 OBO. Located in Sioux Falls, South Dakota.

We have a Boss VBX 8000 salter. The bearing is pretty stuck on us and we're having a lot of trouble getting it out to replace it. It's all pretty rusty and we're having trouble getting the rod to seperate from the bearing or the auger. Does anybody have any experience or ideas that might be...

So, has anybody else ever seen a Boss plug mounted to the chromed front bumper of a new truck? What do you think of this install job from my local shop? I paid $$$$$$ for this...

Bought last season very well kept. Been stored inside and treated by Krown. In perfect condition. 12k for both.

picked up brand new dxt today. just kept old controller hooked up as never had issue with it. something odd when going to hook up, put in float verified red light on dealer went to hit switch 90 seconds later and nothing. in cab float off had to flip power button off/on to get it. worked fine...

Just bought from the boss dealership last year. Used one season and was stored inside on off season. Perfect condition. Comes with everything except the wiring harness and plow mount. Includes all paperwork. It’s ready to go. Email me if interested. $12,500.00

Lost the adapter from my truck to my boss plow controller. looking for someone who can send me a link to the part I need. I have a 2006 Nissan Titan. The pc I need fits between the 2 images.

I need some help/advice. My plow is being put on but they said the sway bar/links are getting in the way of the plow bracket. I'm maybe thinking when the lift was installed they didn't add extended sway bar links. So should I buy longer sway bar links or is there an easier way around it.????

I have a boss plow that quits working and then I have to re connect the 13 pin to get it to start again. Happens every 5 minutes. Appreciate any help on where to look.

Hello. I have a 8 2 boss v plow. I can’t get anything to move or the motor to run but it works when I jump the solenoid. I replaced the solenoid with a brand new one and the problem still exists. Solenoid clicks but the motor only engages when I jump it with a screw driver. I appreciate any help

Ok so I have a boss superduty, near the end of last season it seemed to be drawing extra power when moving, other then that good though. This year slightly worse it almost puts my gauge in the red when doing full raise or full angle (full left to full right etc) and the market lights draw a lot...

I’m currently troubleshooting a wing extend problem i’v been having since the last snow fall. When I try and extend the wings simultaneously, the left wing extends normal and the right wings starts about half way and than stops until the left extends all the way. This was not the case until the...

I am currently trading in my 2018 ram 2500. I have a boss plow installed on it. 8'6" Stainless steel v plow. I am buying a ford and therefor need to buy a new push plate plus the labor to install it.. I am thinking about just installing a new plow altogether. That will only happen if i well the...

Selling my Boss TGS 800 Lightly used, and always well maintained/properly cleaned out Perfect working order. We are a father/son business and are getting out of the plow business due to my father being diagnosed with cancer. We are moving to get him the best care possible. *Only the salter is...

Good Morning. I have a 2018 Ford F350 and a Boss V Plow. Last night I disconnected my plow from the truck (60 degrees this weekend) and have no headlights. When I plow I flip the aux 1 switch to control the plow lights. When I disconnect I turn off the aux 1 and can control my truck lights as...

Nice strong enclosed UTV with dump bed. New 540 CCA LTV Odyssey battery. Good tires. Cab heater. Windshield Wiper. Front roof work LEDs. Fold out windshield. Differential Lock. 4x4 select switch. Ready to work. Great machine. Selling to help purchase upgrade. $12,000 Will consider trades (or...