Snow Plowing Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. Chevy Trucks
    So at about 60 mph i start to get a bit of a shake, nothing else i can notice up to there. As speed increases so does the shake until about 75 mph it feels like Im on washboard gravel, then at 80 mph, nothing wrong, drives smooth. Im not sure where to start on this one, maybe front driveshaft...
  2. Chevy Trucks
    Ok I Am Very Pressed for Time I'm hoping For a Miracle of someone who happened to have had this ******* Bizarre, Twisted Prohlem. I Will Respond, I can Take a Joke and Please Help Me If You Can I'll Be Brief. Truck: 2001 Chevy Silverado 2500hd 6.0 Gasser. 160k miles or potentially 240k due to a...
  3. Truck & Equipment Repair
    looking to see what remedies might be out there for a GM 6.0 Vortec motor to increase gas mileage. I have 2 of these: Escalade which I upgraded the exhaust (cat back) and put a K&N air filter on. Increased mileage about 1.5 (13 to 14.5 daily type driving) and seemed to offer more power. Did...
  4. Ford Trucks
    I just recently started having problems starting my 6.0 in my Excursion. The engine seems to be cold (outside air a balmy 41 degrees). If I wait for the pre-heater light to go away, crank it, maybe one or no cylinders fire and kick over. I turn off the ignition and try again, it turns over a...
  5. Chevy Trucks
    just wanted to throw out a heads up to everyone. stopped in the local chevy dealer yesterday looking at trucks, diesel trucks, but he told me that for the 2010 line, the 6.0 gasser will be discontinued across the board, so a 5.3 will be it, in everything from a 1500-3500hd. :crying: so if you...
  6. Chevy Trucks
    I am going to be replacing the intake gasket on my 2000 2500 with the 6.0 V8. I was wondering if there is anything I should look out for, or any tips anyone can give on how to make the install quicker/easier. Any input would be much appreciated.
  7. Fisher Engineering Discussion
    My 2000 Siverado 2500 is a not an HD version, not many of these 2500's out there, I have the 6.0 liter engine, the plow really pulls down the front end, I do not want to install Tiimbrens, really do not want to crank up the torsion bars, can I upgrade the Torsion bars. I do not use a ballast...
1-7 of 7 Results
Top