Snow Plowing Forum banner

would like to know what guys you think

1K views 3 replies 2 participants last post by  show-n-go 
#1 ·
I just got a used diamond md2 7'6 plow I going to put it on a 08 dodge dually and I need to make it a 8'6 foot I can make the mold board out of 3/16 steel and get a 8'6 cutting edge but the cutting edge will be 6 inches on each side past the pin for the trip edge do you guys think it will work ok
 
#4 ·
oh, my bad i missed that in your first post.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top