1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

webster pump with 6 niods wireing help

Discussion in 'Truck & Equipment Repair' started by Fathermidnight, Nov 8, 2009.

  1. Fathermidnight

    Fathermidnight Junior Member
    Messages: 1

    I have a very old boss v plow that is controlled by a webster (part number) 86718 , It have three toggles to control it - up, gravity down- right forward and back - left forward and back- it came off a 81 chev 4x4 and was remounted to a 82 chev 4x4 i have all the wires connected except three which were removed by my brother, the two are going to the controls and the other is a small red fused line to the pump motor solenoid any one have any ideas , ill even take pictures and email them to you Thanks
     
  2. Crash935

    Crash935 2000 Club Member
    Messages: 2,377

    a little history on the pump

    1985 – 1988 Webster (Rubicon)
    Gold colored reservoir held on w/ 8 bolts.
    HVI Valve Manifold remotely mounted (not attached to power unit)
    Service Parts:
    • Motor HYD01666 or replace with HYD01600

    switch wiring schematic

    http://service.bossplow.com/Documents/v-blade_rocker_box_wiring_diagram.pdf

    i think this is the wiring schematic you need

    http://service.bossplow.com/Documents/11_pin_wiring_schematic.pdf

    if you didnt find what you need, look around here

    http://service.bossplow.com/DocumentList.aspx?CategoryID=183