1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

unimount controller problem stayin connected

Discussion in 'Western Plows Discussion' started by jdilliplane1, Dec 24, 2010.

  1. jdilliplane1

    jdilliplane1 Senior Member
    Messages: 110

    Hey, My issue is my controller acts weird, but when I hold the two 6 pin connectors together then it works as it should. Short of putting dialectic grease in there, is there any way to keep the connectors together properly. Doesn't seem like they lock or snap together?
     
  2. twinman326

    twinman326 PlowSite.com Addict
    Messages: 1,683

    Try to spread the pins apart (very little or you will break them) using something small.. DO not spread the too MUCH..sounds like they are not making good contact. If you feel safe, use black electrical tape and wrap aroung the plug...

    OR you might have a break in one of the wires..

    Try that, I did and it works.........