1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

Uneven wear? V 9.2 Rt OLDER

Discussion in 'Boss Plows Discussion' started by MowingisMaddnes, Nov 29, 2008.

  1. MowingisMaddnes

    MowingisMaddnes Member
    Messages: 85

    Uneven wear? V 9.2 Rt OLDER and not contacting ground properly...

    What is wrong with my plow? I put new cutting edges on my plow tonight, because the passenger side was almost worn down to nothing after two snow events. Also, the edge is off the ground in the middle when in the V position and off the ground on the ends in the scoop position. I know there is a way to adjust the plows forward or back wards tilt, but I have had no luck with adjusting it in the past to fix the problem. The wear on the passenger side cutting edge was only after two snow events? I can't keep blowing through edges? Help...



  2. Mark Witcher

    Mark Witcher Senior Member
    Messages: 604

    You need to raise the push beam one set of holes or increase the ride height of the truck.
  3. lawnmasters2006

    lawnmasters2006 Senior Member
    Messages: 215

    i agree....
  4. MowingisMaddnes

    MowingisMaddnes Member
    Messages: 85

    push beam holes

    Where exactly are the push beam holes? Thanks, aj
  5. B&B

    B&B PlowSite Fanatic
    Messages: 12,777

    You've got a bigger problem than just the push beam being set too high if it wore an edge out in only two storms. Something is bent or worn....

    Could be the push frame, horizontal hinge pin, or the mount itself...even a sever passenger side lean of the truck itself possibly.

    Time to go over it with a fine toothed comb.
  6. hotshot4819

    hotshot4819 Senior Member
    Messages: 231

    there is a plus side , i bet you scrap the pavement BARE , haha.

    maybe the money you save in salt, you can just put towards edges.
  7. themechanic43

    themechanic43 Junior Member
    Messages: 24

    Adjust the turnbuckle
  8. MowingisMaddnes

    MowingisMaddnes Member
    Messages: 85

    Adjust the turnbuckle

    How do you Adjust the turnbuckle?
  9. themechanic43

    themechanic43 Junior Member
    Messages: 24

    I may be wrong on that, let me research a bit and get back.