1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

Time for some new angle cylinders for my xblade

Discussion in 'Fisher Engineering Discussion' started by Santry426, Dec 29, 2012.

  1. Santry426

    Santry426 Senior Member
    Messages: 419

    Think i'm getting some of my side to side play from my cylinders being worn where my pins connect. I see so many different part numbers listed. Does anyone know which one my 8ft xblade should take
  2. LON

    LON Senior Member
    Messages: 749

    56603K cylinders
    22260 clevis pins
  3. Santry426

    Santry426 Senior Member
    Messages: 419

    Aren't those cylinders like 200 a piece ? Thought they were for the vblades
  4. Tony350

    Tony350 Senior Member
    Messages: 546

    Just a thought to save you some money could you take and ream them out and then press a bushing in there to tighten it up. Also I would bet that if your cylinders and ovaled so is the aframe and the plow where they pin in are also. Just a thought.
  5. chevyzrule810

    chevyzrule810 PlowSite.com Addict
    Messages: 1,214

  6. RC51

    RC51 Junior Member
    from USA
    Messages: 10

  7. Santry426

    Santry426 Senior Member
    Messages: 419

    Thanks guys!
  8. 2COR517

    2COR517 PlowSite Fanatic
    Messages: 7,115

    There is always going to be some play. Might be worth pulling the pins and inspecting. You will probablyfind the pins, cylinders, and frame are all worn.