1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

Snowdogg Rep?

Discussion in 'SnowDogg Snow Plows' started by chopshop, Nov 19, 2009.

  1. chopshop

    chopshop Junior Member
    Messages: 1

    I am sorry if this has been addressed but I searched the site with no result. I have a Universal Snowdogg Controller for a fisher plow that I used last year without problem. I think I accidently reprogrammed the remote and I lost my manual. If someone could give me the directions for reprogramming or a manual I would greatly appreciate. Thank you,
    Jim
     
  2. smoorman

    smoorman Sponsor
    Messages: 446

    1. Remove power from the controller (turn off the truck)
    2. Hold down the UP/DOWN buttons (LIFT/LOWER) at the same time
    3. Apply power to the controller – hold the up/down for about 5 seconds.
    4. All the lights will start to blink
    5. Hit RIGHT until the lights stop blinking, and ONLY THE STATUS LIGHT should be blinking, 1, 2, 3, or 4 times.
    6. Use the top of the LEFT and RIGHT buttons to cycle through the modes (LEFT is down, RIGHT is up).
    7. Fisher/Western is MODE 2
    8. When the mode has been selected, hit POWER to lock it in.

    That should take care of it.
    Regards,
    Scott