1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

Snow ex error codes

Discussion in 'SnowEx Products' started by newtland, Dec 6, 2011.

  1. newtland

    newtland Junior Member
    Messages: 7

    Hi I just hooked up my snowex 8500 today and the controller is flashing and beeping a L6 code. I have never seen this code before. does anyone know what it means. thanks.
  2. clark lawn

    clark lawn PlowSite.com Addict
    from NE ohio
    Messages: 1,233

    Its Lb or low battery. Check your connections.

    TOP NOTCH Junior Member
    Messages: 3

    I was hooking up my spreader today and getting a error code of E-3 does any body know what this is. When I turn the switch the spinner will spin and then stop a couple of seconds later then give me a error code, can only help me out Chris@lotstriper.com

    TOP NOTCH Junior Member
    Messages: 3

    Sorry the error code is E0 flashes on the sprinner and auger controls, can anyone tell me what this means, thanks Chris@lotstriper.com 610.496.7403
  5. highhog1

    highhog1 Senior Member
    Messages: 112

    Chris, is the motor plugged in when you turn the control box on? EO usually means that it is not completing the circuit. Everthing needs to be connected. I had the same problem.. if you go to snowex website you can download all the manuals you need plus troubleshooting guides. Hope this helps. Also make sure there are around 11-12 volts going to the control box and motor.