1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

Sno-Way Wireless Transmitter Not Working

Discussion in 'Truck & Equipment Repair' started by seahammer, Dec 29, 2012.

  1. seahammer

    seahammer Junior Member
    from N.Y.
    Messages: 3

    I attempted to put my plow (Sno-Way 26 Series, Down Pressure, Wireless Transmitter) on the truck today and I kept getting the message "NO RECEIVER" on my Wireless Transmitter. Tried to pair the Transmitter with the Receiver following the directions in the Sno-Way Manual . The Transmitter read "PAIRING REMOTE" but it would not get past that. The LED light on the Receiver does not light up at all. Any suggestions?
     
  2. basher

    basher PlowSite Fanatic
    from 19707
    Messages: 8,992

    Check your power supply and all fuses
     
  3. seahammer

    seahammer Junior Member
    from N.Y.
    Messages: 3

    Basher - Thanks for the reply.
    I checked for power and the fuses like you said.
    There is power all the way to the 14 pin connector and the (2) fuses are good (the one at the battery and the 10amp by the solenoid).
    I tried the wireless transmitter again and it is still saying "NO RECEIVER".
    Not sure if LED on the Module should be on, but it is not.
    ???
     
  4. basher

    basher PlowSite Fanatic
    from 19707
    Messages: 8,992

    My guess is a bad receiver
     
  5. seahammer

    seahammer Junior Member
    from N.Y.
    Messages: 3

    Basher-Thanks for your help.
    Do you stock this part?