1. Welcome to PlowSite. Notice a fresh look and new features? It’s now easier to share photos and videos, find popular topics fast, and enjoy expanded user profiles. If you have any questions, click HELP at the top or bottom of any page, or send an email to help@plowsite.com. We welcome your feedback.

    Dismiss Notice

should be simple question for most

Discussion in 'Western Plows Discussion' started by tecate1987, Dec 11, 2010.

  1. tecate1987

    tecate1987 Junior Member
    from pa
    Messages: 29

    got western mark III arismatic,
    I took the hoses off to drain the fluid out, I didnt mark the lines as to which line goes to the right angle and left angle.
    looks like off the pump there is a hole top and bottom, which is for right and left

    they will not go one one way as I have only threaded hole in the pump area
     
  2. twinman326

    twinman326 PlowSite.com Addict
    Messages: 1,683

    There is threads on the hoses?

    A quick coupler should of been on one hydra turn ram, and another quick coupler on the pump it self???

    Look at this thread.There is a pic in post #2..
    http://www.plowsite.com/showthread.php?t=111808

    Look like the pass side goes to the top, and the driver side goes to the bottom...
     
    Last edited: Dec 11, 2010
  3. tecate1987

    tecate1987 Junior Member
    from pa
    Messages: 29

    yes the ends are threaded. when I took them off the pump area all fittings and lines came off so there was just the threaded holes
     
  4. twinman326

    twinman326 PlowSite.com Addict
    Messages: 1,683

    that the only two open holes?
     
  5. tecate1987

    tecate1987 Junior Member
    from pa
    Messages: 29

    same fittings sizes for both, which one is for left and which one for right
     
  6. twinman326

    twinman326 PlowSite.com Addict
    Messages: 1,683

    Re-read post two on here..

    Look like "pass side" goes to the top.
    Driver side below..

    Try it and see what happens..If it wrong, then reverse them
     
  7. snowplowpro

    snowplowpro Senior Member
    from NJ
    Messages: 901

    go on to the western website and in the mechanics guide page 7 it will show you a picture of it.
     
  8. tecate1987

    tecate1987 Junior Member
    from pa
    Messages: 29

    got it, I had some other issues with it so I didnt want to hook it up wrong, cuz I might not know just by doing this. I was having issues with angle which is why I changed fluid

    THX
     
  9. lukynskywyrd

    lukynskywyrd Member
    from wisc.
    Messages: 54

    My Isarmatic.......

    the top hole of the manifold on the pump gets the quick connector. This connects to the hose from the angle ram on the plow. The bottom hole of the manifold gets the threaded end of the hose and this attaches to the quick connect on the plow.